INCH-POUND
MIL-PRF-62315C
25 July 1997
SUPERSEDING
MIL-H-62315B(AT)
3 December 1990
PERFORMANCE SPECIFICATION
HEATER ASSEMBLY, COMBUSTION
VEHICULAR COMPARTMENT, 60 000 BTU/HR
This specification is approved for use by all Departments and Agencies of the
Department of Defense.
1. SCOPE
1.1 Scope. This specification establishes the performance, design, testing,
manufacturing, and acceptance requirements for a forced air inlet personnel heater assembly,
referred to herein as "heater" (see 6.1).
1.2 Classification. Heaters will be dual or single air of the following types (see 6.4.1
and 6.4.2):
Type I
- Extended operating range.
Type II
- Standard operating range.
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all
specified requirement documents cited in sections 3 and 4 of this specification, whether or not
they are listed.
Beneficial comments (recommendations, additions, deletions) and any pertinent data which
may be of use in improving this document should be addressed to: U.S. Army Tank-automotive
and Armaments Command, ATTN: AMSTA-TR-E/BLUE, Warren, MI 48397-5000, by using
the Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of
this document, or by letter.
AMSC N/A
FSC 2540
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business